West Control Solutions DataVU 7 - Manual (Page 146)

21 Configuration - Counters/Integrators
146
Stop and restart will occur at the next point in time which fits into the time grid,
dependent on the Synchronization time (Synch. time) and Period.
Example:
Period = 2 hours
Synchronization time = 11:30:00
Power ON = 09:11:00
1. Period 1 from 09:11 to 09:30 = 19 minutes
2. Period 3 from 09:30 to 11:30 = 2 hours
3. Period from 11:30 to 13:30 = 2 hours
etc.
Start Start is the start time for counters or integrators which have the parameter
Type configured for “Daily (start…end)”.
End End is the end time for counters or integrators which have the parameter Type
configured for “Daily (start…end)”.
Period Period is the period length for counters and integrators which have the
parameter Type configured for “Periodic”.
Weekday On Weekday at the Synchronization time, counters and integrators which have
the parameter Type configured for “Weekly” are stored and restarted with the
start value 0.
Reset
signal In addition to the normal end, a signal can be determined here with which the
counter/integrator counts can be set to 0.
Note
H
The current states are not stored. This function proves useful for
setting up a plant (test run), for instance.
H
The „General Setting“ can be be taken out of effect for each
counter/integrator with a specific setting.