West Control Solutions ProVU 4 - Manual (Page 48)

ProVU4 Controller, Profiler & Recorder/Controller - Product Manual
59407, Issue 1 – March 2008 Configuration & Use Page 47
Supervisor Mode
This mode is only available if it has been configured from the PC software. The software is
used to copy up to 50 screens from the Configuration Menus to include in Supervisor Mode.
The purpose of Supervisor Mode is to allow certain users access to a lock code protected
sub-set of the main configuration parameters without providing them with the higher level
Configuration Menu unlock code.
Entry into Supervisor Mode
CAUTION:
Adjustments to these parameters should only be performed by personnel
competent and authorised to do so.
Supervisor Mode is entered from the Main Menu
Hold down

and press

from to enter the Main Menu.
Press

or

to select Supervisor Mode
Press

to enter the Supervisor Mode.
Note:
Entry into this mode is security-protected by the Supervisor Mode Lock Code. Refer to the
Lock Code View section for more details.
Navigating in Supervisor Mode
Press

to move forward or

to move backwards through the screens.
Press

or

to change the value as required.
Hold down

and press

to return to the Main Menu
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
Table 7. Supervisor Mode Screens
 Supervisor Mode:
Supervisor Mode
Unlocking If Supervisor Mode is configured, enter correct code number to
continue.
- Supervisor Mode
Screens …
Press  to select each parameter in turn. Follow on-screen prompts
to alter the values.