Main menu, Entry into the main menu, Navigating the main menu – West Control Solutions ProVU 4 User Manual
Page 46: Unlock codes

ProVU4 Controller, Profiler & Recorder/Controller - Product Manual
59407, Issue 1 – March 2008
Configuration & Use
Page 45
Main Menu
This menu is used to access the various features and configuration menus available in the
instrument. The available menus are dependent upon the features and options fitted and the
way in which it has been configured
Entry into the Main Menu
Holding down
and pressing
from Operation Mode and most other screens will
cause the unit to enter the Main. Each time this key press sequence is made, the
instrument moves to the next menu level above. Sub-menu levels will require this
sequence to be pressed more than once in order to reach the main menu.
Navigating the Main Menu
Once in the Main Menu, press
or
to select the required option
Press
to enter the chosen menu.
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
Unlock Codes
To prevent unauthorised entry, most modes require a pass-code (1 to 9999) to gain entry.
These modes are indicated by the symbol against their names. The default unlock code
for all modes is 10 and the current codes can be viewed and changed from the Lock Code
View in Configuration Mode. For security, users should to change the codes. If the
Configuration Mode lock code is lost, refer to the Lock code View section of this manual.
Table 5. Main Menu Screens
Main Menu:
Display of the process and setpoint values, selection/adjustment of
the Setpoints, auto/manual control, alarm/event status, trend view and
where available, data recorder and profile information.
Easy, step-by-step parameter setup for simple applications.
If configured from the PC software, a sub-set of up to 50 Configuration
screens can be accessed.
Accesses the sub-menus for Input; Control; Outputs; Alarms;
Communications; Recorder; Clock; Display; Lock Codes and Reset
To Defaults menus and functions.
Selection of Pre-Tune, Self-Tune and Auto Pre-Tune.
Setting of Global Control Parameters for all profiles; Profile creation,
editing and deletion.
Selection of profiles. Running, holding or aborting of profiles.
Uploading/downloading instrument configuration, profile information
and data recordings.
Manually starting, stopping and deleting recordings.
Instrument information, including features and options installed.
Contact information for service/support etc.