West Control Solutions N6600 User Manual
West Control Solutions Equipment
Table of contents
Document Outline
- VOLUME 1 - OPERATING INSTRUCTIONS
- INTRODUCTION
- OPERATOR MODE
- INTRODUCTION
- SELECTING THE PARAMETER TO BE DISPLAYED/ADJUSTED
- ADJUSTING THE DISPLAYED PARAMETER
- SOFT START
- INDICATION OF AN ALARM GOING ACTIVE
- ALARM STATUS DISPLAY
- OVER-RANGE/UNDER-RANGE DISPLAYS
- SENSOR BREAK INDICATION
- OUTPUT TURN OFF
- MANUAL CONTROL MODE
- HEATER CURRENT DISPLAY
- SOFT START IN PROGRESS
- QUICK TRANSFER OF HEATER CURRENT TO NOMINAL VALUE
- PRE-TUNE
- SELF-TUNE
- TO VIEW THE HARDWARE DEFINITION CODE
- SET UP MODE
- ENTRY INTO SET UP MODE
- SET UP MODE PARAMETERS
- Table 3-1 Set Up Parameters
- Input Filter Time Constant
- Process Variable Offset
- Output Power 1
- Output Power 2
- Proportional Band 1
- Proportional Band 2
- Reset (Integral Time Constant)
- Rate (Derivative Time Constant)
- Overlap/Deadband
- Bias (Manual Reset)
- ON/OFF Differential (Hysteresis)
- Setpoint High Limit
- Setpoint Low Limit
- Recorder Output Scale Maximum
- Recorder Output Scale Minimum
- Output 1 Power Limit
- Output 1 Cycle Time
- Output 2 Cycle Time
- Process High Alarm 1 Value
- Process Low Alarm 1 Value
- Band Alarm 1 Value
- Deviation (High/Low) Alarm 1 Value
- Alarm 1 Hysteresis
- Process High Alarm 2 Value
- Process Low Alarm 2 Value
- Band Alarm 2 Value
- Deviation (High/Low) Alarm 2 Value
- Alarm 2 Hysteresis
- Heater Current High Scale Limit
- Heater Nominal Current
- Low Heater Break Alarm Value
- High Heater Break Alarm Value
- Short Circuit Heater Break Alarm Enable/Disable
- Soft Start Setpoint
- Soft Start Time
- Auto Pre-Tune Enable/Disable
- AM Key Usage
- Setpoint Ramp Enable/Disable
- Communications Write Enable/Disable
- Setpoint Strategy
- Lock Value
- OPERATOR MODE DISPLAYS
- TUNING THE CONTROLLER MANUALLY
- SELF-TUNE
- EXIT FROM SET UP MODE
- MODBUS RTU COMMUNICATIONS
- COMMUNICATIONS WRITE ENABLE/DISABLE
- PHYSICAL REQUIREMENTS
- MODBUS RTU PROTOCOL
- INDIVIDUAL PARAMETERS
- Input Parameters
- Output Parameters
- Heater Current Parameters
- Setpoint Parameters
- Soft Start Parameters
- Alarm Parameters
- Tuning Parameters
- RATE (DERIVATIVE TIME CONSTANT) - Word Parameter 9
- RESET (INTEGRAL TIME CONSTANT) - Word Parameter 8
- MANUAL RESET (BIAS) - Word Parameter 15
- ON/OFF DIFFERENTIAL - Word Parameter 17
- OVERLAP/DEADBAND - Word Parameter 16
- PROPORTIONAL BAND 1 VALUE - Word Parameter 6
- PROPORTIONAL BAND 2 VALUE - Word Parameter 5
- Status Parameters
- ASCII COMMUNICATIONS
- Alphabetical Index - Volume 1
- VOLUME 2 - INSTALLATION & CONFIGURATION INSTRUCTIONS
- INSTALLATION
- INTERNAL LINKS AND SWITCHES
- CONFIGURATION MODE
- PRODUCT SPECIFICATION
- Alphabetical Index - Volume 2