West Control Solutions N6600 - Manual (Page 20)

3-4 O075-3
PM-0075
Parameter Legend Adjustment Range Default
High Heater Break
Alarm level (% or
amount above
nominal heater
current)
1% to 100% (of nominal) and 0
(OFF) or 0.1A/1A to Heater
Current High Scale Limit
0 (OFF)
Short Circuit Heater
Break Alarm 10
0 (disabled) or 1 (enabled) 1 (enabled)
Soft Start Setpoint Range Min. To Range Max. Range Min.
Soft Start Time 15s to 59m 45s and 0 (OFF) in
15-second increments
0 (OFF)
Auto Pre-Tune
Enable/Disable
0 (disabled) or 1 (enabled) 0 (disabled)
AM Key Usage Output Turn-off
Manual Control
Heater Current
display/Manual
Control Disable
SP Ramping
Enable/Disable
0 (disabled) or 1 (enabled) 0 (disabled)
Comms. Write
Enable/Disable 6
0 (disabled) or 1 (enabled) 1 (enabled)
Setpoint Strategy 1 or 2 1
Lock Value 0 to 9999 10
OPERATOR MODE DISPLAYS
(still accessible in Set Up Mode)
PV/Active SP See Subsection 2.2 -
PV/Heater Current Read Only -
SP or SP1
8 SPHi to SPLo SPLo
SP2 (Dual SP only) SPHi to SPLo SPLo
Ramping SP value
5 Read Only -
SP Ramp Rate 7 1 to 9999 and OFF OFF
Soft Start Time
Remaining
Read Only -
Alarm Status Read Only (see Subsection 2.6) -
Table 3-1 (Cont.) Set Up Parameters