West Control Solutions N6600 - Manual (Page 92)

3.2.3 Heater Break Input Type
The following input types are available:
Selection/confirmation is achieved with the Raise/Lower and AM keys, as
previously described.
3.3 CONFIGURATION MODE PARAMETERS
3.3.1 Input Range
When Configuration Mode is first entered, this parameter will be displayed in the
form:
The default setting is dependent upon the input hardware fitted, as indicated by
the first (left-most) digit of the Hardware Definition Code (see Subsection 3.2.1):
If the Hardware Definition Code is at its default setting, input code 1419 will be
displayed. The input ranges and codes available are listed in Appendix A.
3-5 S075-3
PM-0075
Input Hardware Fitted Default Setting
Thermocouple 1419 (Type “J”, 0 to 760 ° C)
RTD (Pt100) 7220 (RTD Pt100, 0 to 800 ° C