West Control Solutions N6600 - Manual (Page 68)

Alphabetical Index - Volume 1
A
Active Alarm
Indication of 2-4
Active Setpoint
Indication of 2-3
Address Range
ASCII protocol 5-2
Address Range - Enhanced RS485
Option
MODBUS RTU protocol 4-5
Address Range - Standard RS485 Option
MODBUS RTU protocol 4-5
Alarm 1 Hysteresis 3-12, 4-14, 5-12
Alarm 1 Value
4-14, 5-12
Alarm 2 Hysteresis 3-14, 4-14, 5-12
Alarm 2 Value
4-14, 5-12
Alarm Status
Display of 2-4
Alarms
Summary description 1-4
AM Key Usage 3-16, 4-16, 5-15
To select automatic
control/output turn-off 2-5
To select automatic/manual
control 2-5
To select heater current
display 2-5
Arithmetic Deviation 4-16
Arithmetic Deviation Value 5-14
ASCII Communications Protocol 5-1
Auto Pre-Tune Enable/Disable
3-16
Automatic Tuning 1-3
B
Band Alarm 1 3-10
Band Alarm 2 3-12
Baud Rate
ASCII protocol 5-1
MODBUS protocol 4-1
Bias 4-15, 5-14
See Also Manual Reset
Broadcast Messages
MODBUS RTU protocol 4-2
Bumpless Transfer 1-3, 2-5
C
Character Transmission
ASCII protocol 5-1
MODBUS RTU protocol 4-1
Communications
MODBUS bit parameters 4-6
MODBUS word parameters4-6
Communications Data Format
ASCII protocol 5-1
MODBUS RTU protocol 4-1
Communications Line Release Time
Maximum Value 5-1
Communications Message
Format 5-2
Configuration Mode
Summary description 1-2
Control
Summary description 1-3
Control Setpoint 5-11
Controller Address
MODBUS RTU message
format4-2
Controller Status 4-16
ASCII Protocol 5-6, 5-14
MODBUS RTU protocol 4-4
Cycle Time
Definition of 1-3
Cyclic Redundancy Checksum
Description of 4-2
Cyclic Redundancy Checksum (CRC)
Description of 4-2
1 O075-IDX
PM-0075