West Control Solutions N6600 - Manual (Page 33)

3.2.39 Communications Write Enable/Disable
This parameter enables/disables Write operations (i.e. the changing of parameter
values/settings) via the RS485 communications link, if the Communications Option
PCB is fitted (0 = Disabled, 1 = Enabled). The default setting is 1 (Enabled).
Parameters can be interrogated via the link, regardless of the setting of this
parameter.
3.2.40 Setpoint Strategy
This parameter determines whether the active setpoint value shown in the
Operator Mode process variable/setpoint display is adjustable or not (1 = not
adjustable, 2 = adjustable). The default setting is 1. NOTE: During a Soft Start, the
active setpoint value cannot be altered, regardless of the setting of this
parameter.
3.2.41 Lock Value
This parameter defines the four-digit code required to enter Set Up Mode. It may
be adjusted in the range 0 to 9999. The default setting is 10.
3.3 OPERATOR MODE DISPLAYS
Once the complete cycle of Set Up Mode parameters has been displayed, the
user may then step through the Operator Mode displays (see Section 2), making
adjustments where required, before re-starting the Set Up Mode parameter cycle,
as shown in Table 3-1.
O075-3 3-17
PM-0075