West Control Solutions N6600 - Manual (Page 49)

1 - 9999 increments per hour or 0 (ramping OFF). The decimal point position is as
for the input range.
4.4.4.3 SETPOINT HIGH LIMIT - Word Parameter 22
This word parameter may be modified/interrogated. It defines the maximum value
which may be assigned to the setpoint. The default value is Input Range
Maximum. The permissible range is between the current setpoint value and Input
Range Maximum. The decimal point position is as for the input range.
4.4.4.4 SETPOINT LOW LIMIT - Word Parameter 23
This word parameter may be modified/interrogated. It defines the minimum value
which may be assigned to the setpoint. The default value is Input Range Minimum.
It may be set to a value between Input Range Minimum and the current value of
the setpoint. The decimal point position is as for the input range.
4.4.4.5 CONTROL SETPOINT - Word Parameter 21
This Read Only word parameter is the setpoint value being used by the Controller
at the instant the message is received. When the setpoint is ramping, this is the
ramping setpoint value.
4.4.5 Soft Start Parameters
4.4.5.1 SOFT START SETPOINT - Word Parameter 37
This word parameter may be modified/interrogated. It defines the value of
setpoint to be used during a soft start. It may be adjusted between Input Range
Minimum and Input Range Maximum. The default value is Input Range Minimum.
4.4.5.2 SOFT START TIME - Word Parameter 38
This word parameter may be modified/interrogated. It defines the duration of the
Soft Start. It may be adjusted in 15-second increments within the range 0 (OFF) to
59 minutes 45 seconds. A value which is not an exact multiple of 15 seconds is
treated as an invalid value. The default value is 0 (OFF).
4.4.5.3 SOFT START TIME REMAINING - Word Parameter 39
This Read Only word parameter is the time remaining for a Soft Start at the instant
the message is received. When there is no Soft Start currently in effect, a value of
0 is returned.
O075-4 4-13
PM-0075