West Control Solutions N6600 - Manual (Page 12)

Soft Start Time, Soft Start Setpoint and power limit are all adjustable in Set Up Mode
(see Section 3). Soft Start is aborted at start-up if the process variable exceeds the
Soft Start Setpoint. Setpoint ramping is inhibited during Soft Start. During a Soft
Start, the Soft Start time remaining at any moment may be read from the front
panel.
2.5 INDICATION OF AN ALARM GOING ACTIVE
If any of the Heater Break Alarms (High, Low or Short Circuit), Alarm 1 or Alarm 2
goes active, the HB/AL indicator will flash.
2.6 ALARM STATUS DISPLAY
(available if one or more alarms are active)
The alarm status display is in the following format:
2.7 OVER-RANGE/UNDER-RANGE DISPLAYS
If the process variable goes under-range or over-range, the upper display will
show the appropriate one of:
2-4 O075-2
PM-0075