West Control Solutions N6600 - Manual (Page 3)

1
8
-DIN & 1
16
-DIN
PLASTICS CONTROLLERS
PRODUCT MANUAL
VOLUME 1
OPERATING INSTRUCTIONS
In normal operation, the operator must not remove the Controller from its housing
or have unrestricted access to the rear terminals, as this would provide potential
contact with hazardous live parts.
Installation and configuration must be undertaken by technically-competent
servicing personnel. This is covered in Volume 2 of this manual.
Contents - Volume 1
1 INTRODUCTION 1-1
1.1 TAILORING THE CONTROLLER TO SUIT YOUR NEEDS 1-2
1.2 HOW IT WORKS 1-3
2 OPERATOR MODE 2-1
2.1 INTRODUCTION 2-1
2.2 SELECTING THE PARAMETER TO BE DISPLAYED/ADJUSTED 2-1
2.3 ADJUSTING THE DISPLAYED PARAMETER 2-3
2.4 SOFT START 2-3
2.5 INDICATION OF AN ALARM GOING ACTIVE 2-4
2.6 ALARM STATUS DISPLAY 2-4
2.7 OVER-RANGE/UNDER-RANGE DISPLAYS 2-4
2.8 SENSOR BREAK INDICATION 2-5
2.9 OUTPUT TURN OFF 2-5
O075-V1 (iii)
PM-0075