Thermo Fisher Scientific CyberScan DO 600 - Manual (Page 23)

15
Parameter Description Factory Default
Clear logged
Data Memory
YES – Select this to clear all the stored data from the
meter’s memory
NO – Select this if you do not wish to clear the stored
data from the meter’s memory
NO
Display
Contrast
Adjust display contrast from 1 - 25
12
Factory Reset Press ENTER if you wish to reset the meter to its
factory default settings. This includes:
 Deleting your calibration data
 Resetting setup parameters to factory defaults
(except date & time)
 Deleting your stored data in the memory
Press ESC if you do not wish to reset the meter.
2.4 Accessing Setup mode when password protection enabled
1. Switch the meter on. The meter goes to measurement mode.
2. Press right arrow key to navigate to other functions on the right-side of
LCD.
3. Press SETP (F1) to go to Setup mode. Login password screen appears. The
meter expects the 5-digit password specified in system setup.
Figure 8: Login Password
1. Press up & down arrow keys to enter the first digit of the password and
then press NEXT (F3) key to move to the next digit.
Note: You can enter ‘00000’ (read-only password) if you wish to view the
setup parameters. You are not allowed to modify any parameter when
you enter ‘read-only password’.