6 remote synchronization output, Remote synchronization output, Figure 2.9 nac style z (class a) wiring – Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel User Manual
Page 35: Figure 2.10 remote sync output
MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
35
Remote Synchronization Output
Installation
2.5.2 Style Z (Class A) NAC Wiring with ZNAC-92 Converter
2.6 Remote Synchronization Output
Synchronization is a feature that controls the activation of notification appliances in such a way that
all devices will turn on and off at exactly the same time. This is particularly critical when activat-
ing strobes which must be synchronized to avoid random activation and a potential hazard to indi-
viduals. Devices connected directly to the control panel’s NACs can be synchronized as described
in “Type” on page 96.
Notification appliances connected to FCPS NAC power supplies require synchronization with the
FACP’s devices. This can be accomplished by connecting the Remote Synchronization Output
from TB2 of the MS-9200UDLS to the sync input of the FCPS-24FS6/8 Power Supply. The
24 VDC signal from TB2 follows, that is mimics, the signal on NAC1. This allows the devices
connected to the power supply to be synchronized with the devices connected to NAC1 on the
FACP.
The Remote Synchronization Output is power-limited and supervised (refer to “UL Power-limited
Wiring Requirements” on page 36). A 4.7 K
ELR resistor must be connected to the end of the
wiring at the remote power supply.
4 Style Z (Class A) Notification Appliance Circuits, supervised and power-limited
Polarized Bells
Polarized Horn
Polarized Horn
Notification Appliance Circuit
polarity shown in alarm state
Polarized Bell
Polarized Strobe
Polarized Strobe
Figure 2.9 NAC Style Z (Class A) Wiring
NAC 1
NAC 2
TB3
TB4
NAC 3
NAC 4
Dummy Load all unused circuits
circuit number
Polarized Bell
Polarized Horns
Polarized Strobes
circuit number
TB1
TB2
9
2
0
0
c
n
a
c
z
.w
m
f
ZNAC-92
1B+ 3B+ 3B- 1B-
2B+ 4B+ 4B- 2B-
TB3
TB4
+ 24V -
NON-RST
POWER
+ 24V -
RST
POWER
TB1
JP7
REMOTE PWR
SUPPLY SYNC
+ -
TB2
Figure 2.10 Remote Sync Output
Remote Power Supply
FACP main circuit board
Remote Sync Output
Sync Input
4.7 K
ELR
9
2
u
d
c
s
y
n
c
.w
m
f