Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel - Manual (Page 124)

124 MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Programming Master Programming Level
Report Style
Pressing 3 while viewing Central Station Screen #2 will cause the Report Style display to toggle
between Point and Zone. Setting the Report Style to Point will program the DACT to report
individual point status to the Central Station. The control panel is capable of monitoring a total of
198 addressable devices. Setting the Report Style to Zone will program the DACT to report zone
status to the Central Station. The control panel is capable of monitoring a total of 99 individual
zones.
 Supervised Phone Line
The Supervised Phone Line feature allows the user to disable the supervision of Phone Line 2 by
the DACT when using an alternate means of secondary transmission path. The factory default
setting is Phone Line 2 supervised.
Pressing 2 for Superv Phone Line while viewing Onboard DACT Screen 2 will cause the following
screen to be displayed:
Each press of the 1 key while viewing this screen will toggle the option between Supervise Phone
Line 2 Yes and No.
ACS/ANN-BUS FAULT 333 000 000 EM EN
LCD_80F FAULT 330 000 000 EM EN
NAC 1 DISABLE 521 001 001 ET ER
NAC 2 DISABLE 522 002 002 ET ER
NAC 3 DISABLE 526 003 003 ET ER
NAC 4 DISABLE 527 004 004 ET ER
CS CALC FAULT 304 000 000 YF
CHARGER FAULT 300 000 000 YP YQ
OPTION CARD 1 FAULT 331 000 000 ET ER
REMOTE SYNC FAULT 332 000 000 OU OV
ZONE DISABLE 570 000 000 FB FU
NAC_KEY_FLT 300 000 000 ET ER
NO_DEVICES_INSTLLD 380 000 000 ET ER
OFF_NORMAL_MESSAGE 308 000 000 LB LX
24_HOUR_TEST 602 000 000 RP
24 HOUR ABNORMAL TES 608 000 000 RY
UPDOWN REQUEST 411 000 000 RB
UPLOAD SUCCESS 416 000 000 RS
DOWNLOAD SUCCESS 412 000 000 RS
UPDOWN FAILURE 413 000 000 RR
GENERAL_ALARM 000 000 000 00 00
GENERAL_SUPERVISORY 000 000 000 00 00
MNS OVERRIDE 580 000 000 00 00
AUDIO MESSAGE 000 000 Message # 00 00
Table 3.11 Event Codes (Continued)
CENTRAL STATION
1=PRIMARY
2=SECONDARY
3=REPORT STYLE POINT
Central Station Screen #2
NOTES:
1. Detector Address 01 will be reported to the Central Station as Point 01, Detector Address 02
as Point 02, with reports continuing in a similar fashion all the way up to Detector Address 99
which will be reported as Point 99.
2. Module Address 01 will be reported to the Central Station as Point 160, Module Address 02 will
be reported to the Central Station as Point 161, with reports continuing in a similar fashion all the
way up to Module Address 99 which will be reported as Point 258.
ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=SUPERV PHONE LINE
On Board DACT Screen #2
SUPERVISE PHONE LINE
1=PHONE LINE 2 YES
Supervised Phone Line Screen