Fire-Lite MS-9200UDLSC Addressable Fire Alarm Control Panel - Manual (Page 122)

122 MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Programming Master Programming Level
The Communication Format is determined by the type of receiver that the DACT is transmitting to.
Consult your Central Station for proper selection or consult our factory representatives. For any
format chosen, the control panel automatically programs all of the event codes.
Select the Communication Format by pressing the corresponding number key while viewing the
Comm Format screen. The following table describes each format:
Event Codes
Pressing 1 while viewing Primary/Secondary Screen #4 will cause the following screen to be
displayed:
Pressing the down arrow key allows viewing of all Events associated with the selected
Communication Format. Pressing the number corresponding to the event displayed in each screen
will display its default event code which can be customized by the programmer. For example,
pressing 1 for Pull Station will display the following screen which allows the Event Code to be
changed from the default value.
The tables on the following pages list all of the Events and their default Event Codes for the various
Communication Formats.
Ademco Contact ID & SIA Formats
The information shown in Table 3.11 is automatically programmed for the Central Station phone
number Event Codes when the Ademco Contact ID or SIA Format is selected. Enter 0s for an
Event Code Setting to disable the report. Disabled reports will not get called to the Central Station.
The programmer may enable the Event Types in programming as described on the previous page.
Screen Selection Communication Format Description
ADEMCO CONTACT ID Contact ID, DTMF, 1400/2300 ACK
SIA 8 Security Industry Association, 8 messages per call
SIA 20 Security Industry Association, 20 messages per call
Table 3.10 Communication Formats
CENTRAL STATION
1=EVENT CODES
Primary/Secondary Screen #4
EVENT CODES
1=PULL STATION
2=MON-USER-DEF-1
3=WATERFLOW
Event Code Screen
PULL STATION
ALARM 000
Event Code Screen
Event Description Ademco Contact ID SIA
Active Zone Point Active Restoral
PULL STATION 115 Zone Point FA FH
MON-USER-DEF-1 115 Zone Point FA FH
WATERFLOW 113 Zone Point SA SH
MON-USER-DEF-2 113 Zone Point SA SH
SMOKE (PHOTO) 111 Zone Point FA FH
DET-USER-DEF-1 111 Zone Point FA FH
SMOKE (ION) 111 Zone Point FA FH
DET-USER-DEF-2 111 Zone Point FA FH
HEAT DETECT 114 Zone Point KA KH
DET-USER-DEF-3 114 Zone Point KA KH
SMOKE DUCT-P 116 Zone Point FA FH
DET-USER-DEF-4 116 Zone Point FA FH
Table 3.11 Event Codes