Vanguard DigiTMR S2 - Manual (Page 89)

REV 1 DIGITMR S2 USER’S MANUAL
84
3.10.4. Erasing Timing Shots
Use the steps below to erase (delete) timing shots from the DigiTMR’s EEPROM or from a
connected USB Flash drive:
a. Start from the “START-UP” menu:
Press the [3] key (SETUP).
b. The following screen will be displayed:
Press the [3] key (SAVE / RESTORE).
c. The following screen will be displayed:
NOTE
Option 5 (COPY TO THUMB DRIVE) will be listed only if a USB Flash drive is
connected to the unit.
Press the [4] key (ERASE SHOT).
If a USB Flash drive is connected, continue to step d.
If a USB Flash drive is NOT connected, continue to step e.
1. SAVE SHOT
2. RESTORE SHOT
3. SHOT DIRECTORY
4. ERASE SHOT
5. COPY TO THUMB DRIVE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. SHOT DESCRIPTION
5. NEXT PAGE
1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS