Vanguard DigiTMR S2 User Manual

Page 68

DIGITMR S2 USER’S MANUAL

REV 1

3.8.3. Checking Cable Hookups

To check the cable hookups:

a. Start from the “START-UP” menu:

Press the

[4]

key (DIAGNOSTICS).

b. The following screen will be displayed:

Press the

[2]

key (CHECK HOOKUP).

c. The following screen will be displayed:

Confirm that the breaker is in closed position and then press the

[START]

key.

d. The test results will be displayed on the screen as shown below and also printed on the

thermal printer:

1 2 3
C - -

MAKE SURE BREAKER IS

IN CLOSED POSITION

THEN PRESS "START"

1. SLOW CLOSE TEST
2. CHECK HOOKUP
3. TEST TRANSDUCER
4. PRINT DATA
5. ENCODER FILTER
6. CONTACT FILTER

1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS