Vanguard DigiTMR S2 - Manual (Page 41)

REV 1 DIGITMR S2 USER’S MANUAL
36
3.4.3. Setting the DigiTMR S2’s Internal Clock
The DigiTMR S2 has an internal clock with a lithium battery. The battery lasts approximately
three years. When a timing shot is stored, the time and date are also stored with the shot.
Follow the steps below to set the unit’s internal clock:
a. Start from the “START-UP” menu:
Press the [3] key (SET-UP).
b. The following screen will be displayed:
Press the [5] key (NEXT PAGE).
c. The following screen will be displayed:
Press the [1] key (SET DATE & TIME)
d. The following screen will be displayed:
Type the date using the keypad.
ENTER DATE
MM-DD-YY
1. SET DATE & TIME
2. SET PRINT MODE
3. SET 50/60 HZ
4. SET LANGUAGE
5. BLUETOOTH DEV RESET
6. PREVIOUS PAGE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. SHOT DESCRIPTION
5. NEXT PAGE
1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS