Vanguard DigiTMR S2 - Manual (Page 111)

REV 1 DIGITMR S2 USER’S MANUAL
106
No “PASS” or “FAIL”
indicators on the tabulated
report. • Test plan was not loaded before performing a test. Load a test plan
and then re-print the tabulated report.
How does one review the
current analysis setting?
• From the “START-UP” menu, press the [3]
key (SETUP).
• Press the [1]
key (ANALYSIS POINTS).
• Press the [3]
key (PRINT SETTINGS). The current AP1 & AP2 settings
will be printed.