Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller FLEXIBLE CONTROL STRATEGIES - Manual (Page 14)

2.5 EXECUTING AN FCS WIRELIST
The procedure to execute the FCS wirelist is provided in the table that follows:
Executing an FCS Wirelist
STEP PROCEDURE
1 Enter a 0 into datapoint B000 to stop FCS execution. The MicroMod logo appears on the display screen.
Outputs will no longer be updated but remain at their current values.
2 Load all of the wirelist values and associated module parameters from the worksheet into the PCS using any of
the methods described in the 53MC5000 PCS Instruction Bulletin (e.g., faceplate push buttons, hand held
configurer, MC5FIG module in 53HC3300, etc.).
3 Configure, as applicable, the PCS System Module (e.g., Display List), Communications Module, External I/O
Table, Trend Module, and Totalizer Module. All of these modules are described in the 53MC5000 PCS
Instruction Bulletin. If these modules were already configured, then step 1 of this procedure did not destroy
their contents.
4 Enter a 1 into datapoint B000 to start executing the FCS wirelist program.
2.6 MODULE TYPES
There are 41 FCS module blocks maximum (four loop controller) which can be catagorized into 15
distinct module types. The 15 module types are listed in the table that follows:
Module Types
ITEM TYPE NAME(S) NUMBER OF
FCS MODULE
BLOCKS
1 Status Display 1 LoaderModule SDT1 1
2 Contact Closure Input Loader Module CCI0-17 1
3 Analog Input Loader Module ANI0-8 1
4 Extended Math Module EMATH A & B 2
5 Math Module MATH A-F 6
6 Logic Module LOGIC A-H 8
7 Parameter Load Modules PLOAD A-E 5
8 Setpoint Generator Modules SPG 0-3 4
9 Deviation/Alarm Calculation Modules D/C 0 & 1 2
10 Proportional Inegral Derivative Modules PID 0 & 1 2
11 Auto/Manual Switch Modules AMS 0-3 4
12 Control Modules CON 2 & 3 2
13 Analog Output Loader Modules ANO 0-4 1
14 Contact Closure Output Loader Modules CCO 0-5 1
15 Status Display 0 Loader Module SDT0 1
2.7 FCS MODULE DESCRIPTIONS
The FCS modules are described in the sections that follow in the same order as they appear in Fig-
ures 2-1, 2-2, and 2-3. Each module section has a description, an inputs table, a function code ta-
ble (where applicable), a table of standard parameter datapoints associated with the module
(where applicable), and an illustration of the module.
Section 2. FCS Modules
3-1TXT
2–7