Luminex 100 IS User Manual, Version 2.1 - Manual (Page 93)

x MAP Technology Software Tour
PN 89-00002-00-070 Rev. A 7 - 29
Enter System
Control Targets
‹ To enter new and changed control targets:
1. Click New CON Targ. from the Maintenance tab. An Update
CON Targets dialog box appears.
Figure 61. Update Control Targets Dialog Box
2. Enter the values listed in the kit manufacturer’s instructions or
Certificates of Analysis included with your controls into the
CON1 and CON2 entry fields.
3. Click OK.
Note: Ensure that the correct
target values are added for
each parameter before clicking
OK. If necessary, re-enter the
information to correct any
incorrect information.