Luminex 100 IS User Manual, Version 2.1 - Manual (Page 118)

100 IS S Users Manual Version 2.1 x MAP Technology
7 - 54 PN 89-00002-00-070 Rev. A
well for failed acquisitions. Samples may fail analysis for many
reasons, including lack of sufficient events, cancel command, heater
out of range, or plate cancellation.
The system automatically analyzes samples according to the kit
manufacturer’s template commands.
Once you start processing a batch, you cannot use it to reacquire
data. If you click the Open Batch button and then hit the cancel
button, the system defaults to the last open batch. If you have used a
batch for acquisition before, the system will not display it in the open
batch list.
Pause a Batch The pause command temporarily interrupts the acquisition process.
For instance, you may need to pause the system during acquisition if
the temperature goes out of the designated range, you need to add
sheath fluid, you need to add a new reagent to your sample group, or
for various other reasons:
‹ To pause.
1. Click Pause on the main screen. The current operation pauses in
whatever state it is in.
Resume
Acquisition
The resume command continues an interrupted acquisition process.
‹ To resume a batch.
1. Click Resume on the main screen. The system begins processing
in the same operation where it paused previously.
Cancel a
Command
The cancel command button cancels the current activity unless the
command is already complete.
You cannot cancel the warmup command.
‹ To cancel a command, follow this step:
1. Click Cancel Cmd on the main screen. The command cancels.
Cancel Acquisition The Cancel All command cancels the entire batch.