Luminex 100 IS User Manual, Version 2.1 - Manual (Page 16)

Luminex 100 IS User Manual Version 2.1 x MAP Technology
2 - 2 PN 89-00002-00-070 Rev. A
Safety Precautions
Read the following safety information before setting up or using the
Luminex 100 IS instruments. A user should be present during
operation. The system contains electrical, mechanical, and laser
components which, if handled improperly, are potentially harmful. In
addition, biological hazards may be present during system operation.
We recommend that all system users become familiar with the
specific safety advisories below, in addition to adhering to standard
laboratory safety practices. The protection provided by the
equipment may be impaired or the warranty voided if the system is
used in a manner not specified by the instructions or by Luminex
Corporation.
Electrical
The Luminex 100 analyzer and Luminex XYP must be connected to
approved power sources. Do not perform maintenance or cleaning of
the system’s electrical components (except for fuses).
One of the following fuse replacement warning labels appears on the
back of the Luminex 100 analyzer, depending if the instrument
contains a Coherent or Uniphase laser: .
Figure 1. Fuse Replacement Warning Label - Coherent Laser
.
Figure 2. Fuse Replacement Warning - Uniphase Laser