Luminex 100 IS User Manual, Version 2.1 - Manual (Page 186)

8 PN 89-00002-00-070 Rev. A
Luminex 100 IS User Manual Version 2.1 x MAP Technology
needle adjust 10
Sample Probe down button 30
sample timed out 8
sample tube holder
product number 2
sanitize 1, 2
decontaminate 22
remove air bubbles 22
with 70% isopropanol 22
sanitize button 21
sanitize the system
decontaminate sample lines 21
sanitize with 70% isopropanol 2
scan in new samples 49
SD system
alarms 5
installation 2
troubleshooting 6
select
product 5, 6
select the product
calibration trend report 7
self diagnostics
run self diagnostics 30
self-diagnostic tests 12
sensitivity 1
sensitivity, specifications 4
session
paste to 66
session results 60
analysis 60
set 16
set up a patient list 46
set up multiple session run 43
setup 3
sheath 1
manually monitor 9
sheath and waste fluids, manually monitor
waste 9
sheath filter 12
maintenance 8
product number 2
sheath flow rate 5
sheath fluid 53
container, product number 2
fill 9
product number 3
sheath fluid container 13
sheath fluid is leaking onto the plate carrier 9
sheath fluid levels 1
sheath fluid, reservoir with 70% isopropanol
2
sheath pressure lower limit exceeded 5
sheath pressure upper limit exceeded 5
shield
warning 10
shut-down procedure 2
software 12, 3, 68, 3
exit 71
initialize 12
software installation
how to 11
software overview
Luminex 100 IS software 2
software specifications 3
dedicated system 3
software, main menu 3
soluble analytes 1
specification
classification laser 5
specifications 5, 6
5
accuracy and precision 4
capacity 4
electronics 6
fluidics 5
general XYP instrument 5
hardware 2
Luminex 100 instrument 6
Luminex 100 instrument optics 5
Luminex 100 IS
bath sonicator 7
Luminex 100 IS performance 3
reporter laser 5
sensitivity 4
speed 3