CONTREX M-Traverse - Manual (Page 55)

3 - 8
FOLLOWER MODE
The M-Traverse is a multi-motor operation that is specifically designed for the precise
control of reciprocating lead/follower motion control applications. Its primary mode of
operation is the Follower mode. This section discusses the set up procedures for the
Follower mode of operation. Refer to
Introduction: Examples of M-Traverse
Applications for an example of the Follower Mode. Refer to Operation: M–Traverse
Operation for instructions on the operation of the Follower mode.
Caution: To avoid damage to your system, the M-Traverse must be calibrated and the
motor drive set up before you enter the Follower mode. Refer to Installation/
Setup: Calibration .
In order to set up the M-Traverse for the Follower mode of operation, Control
Parameters must be entered for the following procedures:
Control Mode Parameter
Follower Scaling Parameters
Preset Parameters
Follower Profile Parameters
Other Follower Parameters