CONTREX M-Traverse - Manual (Page 134)

4 - 7
Keypad Test #6 - To Test the Keypad
To enter this test, press the “Status” key to increment (or the
“Tach” key to decrement) until the number “6” is visible on
the right side of the upper LED display.
Press “Enter” to start the test.
The lower LED display remains blank until you press the
keypad keys.
Press each of the keypad keys and verify against the follow-
ing list:
Press Display
— —
. .
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
SETPOINT 10
TACH 11
BATCH COUNT 12
STATUS 13
ENTER 14
CODE SELECT 15
* CLEAR No display
* If “Clear” is functioning, pressing “Clear” will take you out of
the Keypad test and you may go to the next test.
If “Clear” is not functioning, it will not take you out of the test
and the number of the prior key (15) will remain on the lower
LED display.
Press Clear”, then “Code Select” only if you want to exit
diagnostics.