CONTREX M-Traverse - Manual (Page 154)

5 - 7
to move the Follower mechanism to “Home”. Jog can also
be used when you need brief bursts of speed to align the
Follower mechanism. When you activate Jog, the RPMs
increase at the acceleration rate that you specified in
Acceleration/Deceleration (CP-60) until the Jog Setpoint
(CP-61) is achieved. When Jog is terminated, the RPMs
return to zero immediately. The Jog direction is deter-
mined by the Jog Forward/Reverse Input (J4, pins 15,16),
which controls the direction of the Speed Command
Output. The Drive Enable discrete output is active during
the Jog mode.
Jog Setpoint See Appendix C; CP-61.
Keypad Error See Appendix C; MV-50.
Lead Frequency See Appendix C; MV-41.
Lead Job Size See Appendix C; MV-80.
Lead Position See Appendix C; MV-43.
Lead PPR Reel See Appendix C; CP-16.
LED Display The two digit Parameter Code is displayed in the lower
LED Display. The Parameter Code's value is displayed in
the upper LED display. This value can be up to six digits.
Line Notch Counter See Appendix C; MV-59.
Max RPM Follower See Appendix C; CP-19.
Mode of Operation The method used to operate your system, for example
Direct mode or Follower mode.
Monitor Variables Monitor Variables (MVs) monitor the performance of the
M–Traverse and the system which the M–Traverse is
controlling. Monitor Variables also confirm the wiring, the
tuning and assist with troubleshooting. MVs can be
accessed at any time during the M–Traverse's operation,
including during Run, Jog and F–Stop. There are four
categories of Monitor Variables: Input Monitoring, Output
Monitoring, Performance Monitoring and Status Monitor-
ing.
Numeric Keys Use the numeric keys to enter a Parameter Code for either