Explanation of terms, Devicenet – Burkert Type 8630 User Manual

Page 136

134 - 8630

EVICE

Explanation of terms

DeviceNet

•

DeviceNet is a field bus system based on the CAN protocol (Controller Area Network). It permits the

networking of actuators and sensors (slaves) with higher ranking control devices (masters).

• In the

DeviceNet the TOP Control Continuous is a slave device according to the Predefined Master/

Slave Connection Set defined in the DeviceNet specification. Polled I/0, Bit Strobed I/O and Change of
State (COS) are supported as I/O connection variants.

• With the

DeviceNet a distinction is made between cyclic or event-controlled transferred process

messages of high priority (I/O Messages) and acyclic management messages of low priority (Explicit
Messages).

• The protocol sequence corresponds to

DeviceNet Specification Release 2.0.

General notes

The following sections of the complete operating instructions are not applicable to the DeviceNet variant
of the TOP

Control Continuous 8630:

• Variants of the TOP

Control Continuous

• First commissioning

• Electrical connection

• Defining the basic settings

Function

INPUT

Function

SPLTRNG

Function

BIN-IN

Function

OUTPUT

Function

CAL.USER / CAL INP

Function

CAL.USER / CAL OUT

Function

CAL.USER / CAL SP