Datamax-O'Neil Class Series II Programmer’s Manual User Manual

Page 37

System-Level Command Functions

Class Series 2 Programmer’s Manual

STX J

Set Pause for Each Label

This command causes the printer to pause after printing each label. It is intended for

use with the peel mechanism or tear bar when the Present Sensor option is not installed.
After removing the printed label, the PAUSE Key must be pushed in order to print the
next label. (The printer must be reset to clear the J command.)

Syntax:

STX K

Extended System-Level Commands

This is an expansion of the System-Level Command structure; see Extended System-
Level Commands for more information.

STX k

Test RS-232 Port

This command instructs the printer to transmit the Y character from the printer’s RS-232
port. (Failure to receive Y could indicate an interfacing problem.)

Syntax:

Printer response:

STX L

Enter Label Formatting Command Mode

This command switches the printer to the Label Formatting Command Mode, where the

printer expects to receive only Record Structures and Label Formatting Commands.
Immediate, System-Level, and Font Loading commands will be ignored until the label

formatting mode is terminated with E, s, or X, (see Label Formatting Commands for
additional information).

Syntax:

This manual is related to the following products:

A-Class Mark II Programmer’s Manual