Datamax-O'Neil Class Series II Programmer’s Manual - Manual (Page 119)

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 105
STX KF Select Factory Defaults
This command restores the configuration of the printer to the factory default settings.
These settings may be default values or the values previously specified by a
configuration file (see Kd).
Syntax: KFn
Where:
n
- 2 = Returns the factory default settings (and, if saved,
restoring the Factory Setting File).
- 3 = Returns the factory default settings, and clears
Calibration and Custom Adjustments.
 Calibration will be required.
STX Kf Set Present Distance
This command specifies an additional amount to advance the label after printing. This
command has the same effect as the f command, but specifies a distance to
advance relative to the start of print (O command) of the next label.
Non-Display Models: The printer Option Control must be set (via the menu) to HOST for
this command to have effect.
Display-Equipped Models: SOP Emulation selection has no effect on this command.
Syntax: Kfnnnn
Where:
nnnn
- A four-digit present distance in inches/100 or mm/10.
Sample:
Kf0100
The sample above represents a one-inch label advance unless in
metric mode (see m).