Datamax-O'Neil Class Series II Programmer’s Manual - Manual (Page 20)

Overview
6 Class Series 2 Programmer’s Manual
Configuration
Command
Name Function
Kf
Set Present Distance
Determines label stop position, head
relative. f edge sensor relative
equivalent command, older models.
Kc
Configuration Set
Determines default power-up
configuration.
F
Send Form Feed
Sets the stop position of the printed
label.
M
Set Maximum Label Length
Length to search for next gap or
reflective mark; not used with
continuous media.
m Set to Metric Mode
Subsequent measurements interpreted
in metric (most units, mm/10). Label
equivalent command can be used.
n
Set to Inch Mode
Subsequent measurements interpreted
in inches (most units in/100) label
equivalent command can be used.
O
Set Start of Print Position
Effect is not on the label immediately
following command since media position
is at Start of Print between labels;
K
default position relative 64
in/100 maximum deviation.
S
Set Feed Rate Sets blank label movement speed.
V
Software Switch
Enables optional hardware, cutter, and
present sensor.