Datamax-O'Neil Class Series II Programmer’s Manual - Manual (Page 137)

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 123
STX Kx Delete Configuration File
This command deletes a configuration file.
Syntax:
KxmName
Where:
m
- Valid Module ID – Range A to Z.
Name - The name, up to 16 characters, of the configuration
file.
- 0x0d terminates the name.
Sample:
KxYPlant1
The sample above deletes the configuration file Plant1 from
Module Y. (Remember to prefix this command with the Module
(Un)Protect Command Kp.)
STX KZ Immediately Set Parameter
This command immediately sets the specified parameter.
Syntax:
KZax
Where: a - Valid parameter identifier, as follows:
F = Feed Speed
P = Print Speed
S = Slew Speed
H = Heat Setting
x
- Speed Parameter Range – A to e (see Appendix L).
-or-
xx
- Heat Parameter Range – A two-digit value (00-30);
see the “H” Label Formatting Command.
Sample:
KZH22
The sample above causes the file currently being executed to
assume a Heat Value of 22.