Atec Fluke-OF-500 - Manual (Page 90)

OF-500 OptiFiber Certifying OTDR
Users Manual
80
Using the Power Meter Option
The power meter option lets you monitor the output
power produced by a source such as an optical network
interface card or optical test equipment. You can also
monitor the power received at the end of the cabling.
You can monitor power at 850 nm, 1300 nm, 1310 nm,
and 1550 nm.
The power meter option is available with OFTM-56x1B,
OFTM-56x2B, OFTM-5731, and OFTM-5732 modules.
Figure 35 shows the equipment needed for using the
power meter.
Note
The power meter option also lets you measure
loss in Far End Source mode.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com