Atec Fluke-OF-500 - Manual (Page 24)

OF-500 OptiFiber Certifying OTDR
Users Manual
14
Changing the Language
To change the tester’s language, do the following:
1 Press S .
2 Press N once to select the System tab.
3 Press L to select LANGUAGE; then press t .
4 Use ML to select the desired language; then press
t .
5 Restart the tester to apply the new language.
Additional languages for the tester may be available
with software updates available on the Fluke Networks
website. Use LinkWare software to install or remove
languages. See “Updating the Tester’s Software” on
page 86 for details.
Removing and Installing the Module
The tester’s capabilities depend on which test module is
installed. Figure 2 shows how to remove the module.
W
Caution
To avoid corrupting the tester's software,
always turn the tester off before removing or
installing a module.