Atec Fluke-OF-500 - Manual (Page 35)

Checking the Tester’s Status
25
Checking the Tester’s Status
The following steps help you verify that the tester is ready
for use.
Checking the Tester’s Status
‰ Check the battery status
Look at the battery icon in the lower-left corner of the
screen or press
F ; then select Battery Status.
A fully-charged battery lasts about 8 hours during
typical use.
‰ Check the space available on the memory card
Insert the memory card you will use, press F ; then
select Memory Status.
To see the status of the internal memory, press
A from the MEMORY STATUS screen.
To view or delete stored records, press v .
To format the memory card press F ; then select
Format Memory Card.
‰ Verify that the installed module can run the tests you
need
The module’s model number is shown in the upper-
right corner of the screen.
To review module capabilities, press H twice; then
select “modules” in the OptiFiber online help index.