Atec Fluke-OF-500 - Manual (Page 70)

OF-500 OptiFiber Certifying OTDR
Users Manual
60
Testing in Smart Remote Mode
Use Smart Remote mode to test and certify dual-fiber
cabling. In this mode, the tester measures loss, length,
and propagation delay on two fibers at two wavelengths
in one or both directions.
Figure 24 shows the equipment needed for testing in
Smart Remote mode.
ajt44f.eps
A
Tester with OFTM-5612B or OFTM-5732 module and
smart remote (DTX remote shown). Match connector
adapters to the connectors in the link.
B Memory card (optional)
C Spare battery pack (optional)
D Two ac adapters with line cords (optional)
E
Two duplex reference test cords. Match the fiber to be
tested. Connectors for the tester and remote outputs
must be SC. For the others match the connectors in the
link.
F Two mandrels. Recommended when testing multimode
fiber. See page 58.
G
Fiber cleaning supplies
Figure 24. Equipment for Loss/Length Testing in Smart Remote Mode
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com