Atec Fluke-OF-500 - Manual (Page 52)

OF-500 OptiFiber Certifying OTDR
Users Manual
42
Using the ChannelMap Function
1 Select ChannelMap mode: On the HOME screen, press
A Change Test; then select ChannelMap.
2 Select a fiber type on the Cable tab in Setup. You do
not need to select a test limit for ChannelMap tests.
3 Clean the connectors on the launch fiber or patch cord
and the channel to be tested.
4 Connect the launch fiber to the OTDR port and the
channel to be mapped. Refer to Figure 15.
5 Press T . Figure 16 describes the features of the
ChannelMap diagram.
6 To save the results, press s , select or create a fiber
ID; then press s again.