Atec Fluke-OF-500 - Manual (Page 82)

OF-500 OptiFiber Certifying OTDR
Users Manual
72
Testing in Far End Source Mode
Use Far End Source mode to measure power or power
loss at one wavelength on individual fibers. A Far End
Source mode record can store dual-wavelength results
from both directions.
Far End Source mode requires a stand-alone optical
source, such as a Fluke Networks DTX Smart Remote with
a fiber module, a SimpliFiber

source, or a LS-1310/1550
Laser Source. Far End Source mode is available on
OFTM-5xx1B and OFTM-5xx2 modules. Figure 30 shows
the equipment needed for testing in Far End Source
mode.
ajt46f.eps
A
Tester with OFTM-5611B, OFTM-5612B, OFTM-5731
or OFTM-5732 module. Match the connector adapter
to the connectors in the link.
B
Optical source (SimplFiber source shown)
C
Memory card (optional)
D
Spare battery pack/ (optional)
E
AC adapter with line cord (optional)
F
Two reference test cords. Match the fiber to be tested.
Match the tester, source, and link connectors as shown
in Figures 31and 32.
G
Mandrel. Recommended when testing multimode
fiber. See page 58.
H Fiber cleaning supplies
Figure 30. Equipment for Loss Testing in Far End Source Mode