Atec Fluke-OF-500 - Manual (Page 55)

Using the ChannelMap Function
45
A The length of the channel, including the launch fiber.
Note
The FIBER LENGTH shown is the actual length of
the channel rounded to the nearest meter or foot
(not the sum of the displayed segment lengths).
B The far end of the channel. The name is set by the
END 1 or END 2 setting on the Job tab in Setup.
C The length of a segment or patch cord rounded to the
nearest meter or foot.
D Press D to add a comment to the ChannelMap
results.
E A reflective event, usually a connector. Could also be a
mechanical splice or a reflective fault such as a sharp
bend or a crack in the fiber.
F The near end of the channel. The name is set by the
END 1 or END 2 setting on the Job tab in Setup.
Figure 16. ChannelMap Diagram Features (cont.)