Atec Fluke-OF-500 - Manual (Page 58)

OF-500 OptiFiber Certifying OTDR
Users Manual
48
Using the FiberInspector Probe
1 On the System tab in Setup, set CAMERA TYPE to match
the magnification you will use. This selects the correct
size for the core size scale.
2 Use the adapter cable provided to connect the probe to
the video input jack on the side of the tester.
3 Screw an adapter tip that matches the connector type
being inspected onto the fiber probe.
4 Clean the connector to be inspected.
5 Press f . If the message “Camera Image
Unavailable” appears check the connections between
the probe and the tester.
6 Place the probe on the fiber connector. Turn the larger
ring on the probe to focus the image. Turn the smaller
ring to change magnification. Refer to Figure 18.
The tester’s softkeys provide additional functions. Press
A More to see other softkey functions.
7 To save the image, press s , select or create a fiber
ID; then press s again.
Figure 19 shows some typical FiberInspector images.