Atec Agilent-E8364B - Manual (Page 124)

120
Table 40 (Continued). Rear Panel Information
Test Set Drivers
Function Used for driving remote mixers
Connectors SMA (f) for RF and LO outputs
RF, LO Output
Frequency Range 1.7 to 20 GHz
RF Output Power
Levels +5 dBm to -16 dBm, depending on frequency
1
LO Output Power
Levels -7 dBm to -16 dBm, depending on frequency
Rear Panel LO Power (Typical)
1.7 GHz- 20 GHz -7 to -16 dBm
Rear Panel RF Power 8362B (Typical)
1.7 GHz to 20 GHz -5 to -16 dBm (at -5 dBm test port power 4 )
Rear Panel RF Power 8363B/8364B (Typical)
1.7 GHz to 10 GHz -2 to -12 dBm (at -5 dBm test port power 4 )
10 GHz to 16 GHz 0 to -8 dBm (at -5 dBm test port power 4 )
16 GHz to 20 GHz +5 to -1 dBm (at -5 dBm test port power 4 )
VGA Video Output
Connector 15-pin mini D-Sub; Drives VGA compatible monitors
Devices Supported:
Resolutions:
Flat Panel (TFT) 1024 X 768, 800 X 600, 640 X 480
Flat Panel (DSTN) 800 X 600, 640 X 480
CRT Monitor 1280 X 1024, 1024 X 768, 800 X 600, 640 X 480
Simultaneous operation of the internal and external displays is allowed, but with
640 X 480 resolution only. If you change resolution, you can only view the
external display (internal display will "white out").
Bias Tee Input Connectors (Option UNL)
Connectors BNC (f), for port 1 and port 2
Fuse 500 mA, bi-pin style
Maximum bias current +/-200 mA with no degradation of RF specifications
Maximum bias
voltage +/-40 Volts DC
Test Set IO
25-pin D-Sub connector, available for external test set control.
Aux IO
25-pin D-Sub connector, male, analog and digital IO.
Handler IO
36-pin parallel I/O port; all input/output signals are default set to negative logic;
can be reset to positive logic via GPIB command.
GPIB
24-pin D-sub (Type D-24), female; compatible with IEEE-488.
Parallel Port (LPT1)
25-pin D-Sub miniature connector, female; provides connection to printers or
any other parallel port peripherals
Serial Port (COM 1)
9-pin D-Sub, male; compatible with RS-232