Atec Agilent-E8364B - Manual (Page 123)

119
Table 40. Rear Panel Information
Description Supplemental Information
10 MHz Reference In
Connector BNC, female
Input Frequency 10 MHz ± 10 ppm, typical
Input Level -15 dBm to +20 dBm, typical
Input Impedance 200
Ω, nom.
10 MHz Reference Out
Connector BNC, female
Output Frequency 10 MHz ± 1 ppm, typical
Signal Type Sine Wave, typical
Output Level +10 dBm ± 4 dB into 50 Ω, typical
Output Impedance 50
Ω, nominal
Harmonics <-40 dBc, typical
External Trigger Rear-Panel I/O (typical)
Trigger Inputs/Outputs BNC(f), TTL/CMOS compatible
Trigger Input
Function Measurement of next point, next channel, or next group of channels
Source Aux I/O (pin 19) or I/O 1 (BNC (f) connector)
Signal Levels TTL-compatible
Input impedance 5 Kohm nominal
Minimum Trigger
Width 1 microsecond
Trigger modes High or low level; positive or negative edge
Trigger Delay Range 0 to 1 second
Trigger Delay
Resolution 6 microseconds (IF bandwidth => 15 kHz) or 6.2 microseconds (IF bandwidth <
15 kHz)
Trigger Output
Function Generate pulse before or after measurement (only active when trigger type is
external)
Source I/O 2 (BNC (f) connector)
Signal levels TTL-compatible
Trigger Polarity Positive or negative edge
Pulse Width 1 microsecond
Option H11 Rear-Panel I/O (typical)
External IF Inputs
Function Allows use of external IF signals from remote mixers, bypassing the PNA's first
converters
Connectors A, R1, R2, B receivers (BNC (f) Connectors)
Input Frequency 8 1/3 MHz
Input Impedance 50
Ω nominal
RF Damage Level -20.0 dBm
DC Damage Level 25 volts
0.1 dB Compression
Point -27.0 dBm
Pulse Inputs (IF Gates)
2
Function Internal receiver gates used for point-in-pulse and pulse-profile measurements
Connectors A, R1, R2, B (BNC (f) Connectors)
Input Impedance 1 Kohm nominal
Minimum Pulse Width 20 ns for less than 1 dB deviation from theoretical performance
3
DC Damage Level 5.5 volts
Drive Voltage TTL; 0 V (off), +5 V (on) nominal