Atec Agilent-E8364B - Manual (Page 122)

118
General Information
Table 38. Miscellaneous Information
Description Specification Supplemental Information
System IF Bandwidth Range -- 1 Hz to 40 kHz, nominal
CPU -- Intel® 1.1 GHz Pentium® M with
1 GByte RAM
Table 39. Front Panel Information
Description Supplemental Information
RF Connectors
E8362B/C
Type 3.5 mm (male), 50 ohm, (nominal)
Center Pin Recession 0.002 in. (characteristic)
E8363B/C AND E8364B/C
Type 2.4 mm (male), 50 ohm, (nominal)
Center Pin Recession 0.002 in. (characteristic)
Display
NOTE: The PNA display must remain in the 16 bit color setting in order to comply with international
emissions regulations.
Size
21.3 cm (8.4 in) diagonal color active matrix LCD; 640 (horizontal) X 480
(vertical) resolution; 59.83 Hz vertical refresh rate; 31.41 Hz horizontal
refresh rate
Refresh Rate Vertical 59.83 Hz; Horizontal 31.41 kHz
Pixels A display is considered faulty if:
• A complete row or column consists of “stuck” or “dark” pixels.
• More than six “stuck on” pixels (but not more than three green) or more
than 0.002% of the total pixels are within the LCD specifications.
• More than twelve “dark” pixels (but no more than seven of the same color)
or more than 0.004% of the total pixels are within the LCD specifications.
• Two or more consecutive "stuck on" pixels or three or more consecutive
"dark" pixel (but no more than one set of two consecutive dark pixels)
• “Stuck on” “dark” pixels are less than 6.5 mm apart (excluding consecutive
pixels)
Display Range
Magnitude ±200 dB (at 20 dB/div), max
Phase ±500°, max
Polar 10 pUnits, min
1000 Units, max
Display Resolution
Magnitude 0.001 dB/div, min
Phase 0.01°/div, min
Marker Resolution
Magnitude 0.001 dB, min
Phase 0.01°, min
Polar 0.01 mUnit, min; 0.01°,min