Atec Agilent-346a - Manual (Page 59)

59
Designing and Probing with Target Connections
Agilent Logic Analyzers with 90-pin Pod Connectors
E5380A 38-Pin Probe
The E5380A is designed to be
compatible with the Mictor
connector. If you have a target
system designed for connection
to the E5346A high-density probe
adapter, the E5380A probe will
connect directly to this same
Mictor connector. (For
information on the E5346A,
refer to pages 28-29). The
maximum state speed when
used with the E5380A probe is
600 Mbits/second. The minimum
input signal amplitude required
by the E5380A is 300 mV.
For further information on designing the E5378A, E5379A, or E5380A probe connectors into your system, refer to the following documents:
Agilent Technologies Logic Mechanical drawings, 16760-97008 http://cp.literature.agilent.com/litweb/pdf/16760-97008.pdf
Analyzer Probes (E5378A, electrical models, general
E5379A, E5380A, and E5386A) information on probes
User’s Guide for logic analyzers with
90-pin connectors
Designing High-Speed Design recommendations, 5988-2989EN http://www.agilent.com/find/probeguide
Digital Systems for Logic examples, and analysis for
Analyzer Probing layout of target systems
38-pin Probe
For probe Agilent
model numbers Description part number
E5378A, E5379A Kit of 5 support shrouds and 5 100-pin Samtec 16760-68702
connectors for PC board thickness up to 1.57 mm (0.062")
Kit of 5 support shrouds and 5 100-pin Samtec 16760-68703
connectors for PC board thickness up to 3.05 mm (0.120")
One 100-pin Samtec connector 1253-3620
(also available from Samtec as part number ASP-65067-01)
One support shroud for 16760-02302
PC board thickness up to 1.57 mm (0.062")
One support shroud for 16760-02303
PC board thickness up to 3.05 mm (0.120")
E5380A Kit of 5 support shrouds and 5 38-pin Mictor E5346-68701
connectors for PC board thickness up to 1.57 mm (0.062")
Kit of 5 support shrouds and 5 38-pin Mictor E5346-68700
connectors for PC board thickness up to 3.175 mm (0.125")
One 38-pin Mictor connector 1252-7431
(also available from AMP as part number 2-767004-2)
One support shroud for E5346-44701
PC board thickness up to 1.57 mm (0.062")
One support shroud for E4346-44704
PC board thickness up to 3.175 mm (0.125")
One support shroud for E5346-44703
PC board thickness up to 4.318 mm (0.700")
Table 9. Mating connectors, shrouds, and kits for Agilent E5378A, E5379A, and
E5380A probes
The E5380A probe combines
two 17-channel cables into a
single-ended 38-pin Mictor
connector. Refer to Table 9 for connector,
shroud, and kit part numbers.
Probing Connector Kit
Shrouds (5)
Figure 10.1. Agilent E5380A probe
38-pin
connectors (5)
See Table 9 for
part numbers