Atec Agilent-346a - Manual (Page 50)

50
Designing and Probing with Target Connections
Agilent Logic Analyzers with 90-pin Pod Connectors
64.48 mm ________
2.538 in.
45.87 mm ________
1.806 in.
21.08 mm ________
0.830 in.
8.76 mm _______
0.345 in.
34.61 mm ________
1.363 in.
27.93 mm ________
1.100 in.
15.26
160.79 mm _________
6.330 in.
6.63 mm _______
0.261 in.
6.63 mm _______
0.261 in.
7.54 mm _______
0.297 in.
5.31 mm _______
0.209 in.
7.54 mm _______
0.297 in.
5.31 mm _______
0.209 in.
Top view E5387A, E5390A
Side view E5387A
Side view E5390A
61.40 mm ________
2.417 in.
48.60 mm ________
1.913 in. 21.11 mm ________
0.831 in.
21.61 mm ________
0.851 in.
8.76 mm _______
0.345 in.
22.05 mm ________
0.868 in.
15.93 mm ________
0.627 in.
45.720 mm _________
18.000 in.
11.00 mm _______
0.433 in.
7.54 mm _______
0.297 in.
5.31 mm _______
0.209 in.
Top view E5398A
Side view E5398A
Figure 8.10. Probe dimensions
Probe Dimensions
The following figures show
dimensions, footprint, and pinout
information you will need to
design your target system board
for use with the Agilent soft
touch probes.