Alarms and snmp, Overview – alarms – Extron Electronics VN-Matrix 200 Series User Manual
Page 90
Alarms and SNMP
This section describes the following:
•
•
Overview – SNMP
•
Overview – Alarms
The VN-Matrix system is configured to generate alarms for error conditions. A list of these
error conditions and their meanings are presented on the following pages.
Alarms can be monitored at a number of locations throughout the web GUI
•
In the Alarms page
•
In the list immediately below the Filter Settings box. This details the alarm
conditions that are currently active on the system.
•
In the Alarm Logs page
•
In the list immediately below the Filter Settings box. This provides a historical log
of when an alarm condition was raised and cleared.
•
In the Device List page
•
Where a traffic light system is used to represent the status of a device.
•
In the top left hand corner of each page in the web GUI.
•
Where the device status and system status is displayed.
In addition the red LED located on the front panel of the VN-Matrix device will illuminate
whenever a critical alarm is triggered.
Alarm conditions, once triggered, will remain active until the error that caused it has
cleared and then for an additional five seconds.
VN-Matrix 200 Series • Alarms and SNMP
85