beautypg.com

Extron Electronics VN-Matrix 200 Series User Manual

Page 120

background image

Output level ................................... TTL: 5.0 Vp-p, unterminated
Polarity ........................................... Positive or negative (follows input)

Audio input/output

Number/signal type ........................ 1 S/PDIF
Source formats ............................... PCM encoded audio, AES/EBU
Connectors .................................... 1 RCA jack

Audio processing

Compression .................................. Audio data is transported without compression by default.

Sampling rate and bit depth decimation may be applied for
uncompressed audio S/PDIF data:
• 16 bit, full sampling rate
• 16 bit, half sampling rate
• 16 bit, quarter sampling rate
Simple run length encoding may be applied for compressed
audio S/PDIF data.

Rates .............................................. 400 kbps to 3 Mbps
Sampling rates ............................... 44.1, 48 kHz

Control/remote — local host — codec, encoder, decoder

Serial control port

VNC 200 DVI ........................... (2) RS-232, male 9-pin D connectors: 1 for host

configuration, 1 for control of other products

All other models ...................... (1) RS-232, male 9-pin D connector, for host configuration

Baud rate and protocol ................... 115200 baud, 8 data bits, 1 stop bit, no parity, no flow

control

Serial control pin configurations ..... 1 = DCD, 2 = Rx, 3 = Tx, 4 = DTR, 5 = GND, 6 = DSR, 7 =

RTS, 8 = CTS, 9 = ring

Keyboard/mouse ports

VNC 200 DVI, VNC 200 DVI-A . 2 PS/2 mouse ports (female 6-pin mini DIN): 1 input, 1 loop

through
2 PS/2 keyboard ports (female 6-pin mini DIN): 1 input, 1
loop through

Ethernet control ports .................... 2* female RJ-45

NOTE:

*Only one of the two RJ-45 ports is used for data and configuration. The other port is

not used.

Ethernet data rate .......................... 10/100/1000Base-T, half/full duplex with autodetect
Ethernet protocol ........................... ICMP (ping), IP, TCP, RTP, RTCP, UDP, DHCP, HTTP, SMTP,

Telnet

System control ............................... VN-Matrix Enterprise Controller, VN-Matrix Enterprise

Retundant Controller
VN-Matrix Web server

Program control ............................. Extron control/configuration software (VNM Viewer, VNM Virtual

Switch) for Windows

®

Extron Command Line Interface (CLI)
Microsoft

®

Internet Explorer

®

and other Web browsers, Telnet

Network transport

Ethernet data rate .......................... 10/100/1000Base-T, half/full duplex with autodetect
Ethernet protocol

Streaming ................................ RTP, RTCP
Transport ................................. TCP, UDP (unicast or multicast)
All supported ........................... ICMP (ping), IP, TCP, RTP, RTCP, UDP, DHCP, HTTP, SNMP V3,

Telnet

Video input/output ......................... PURE3

Codec compression

VN-Matrix 200 Series • Reference Information

115

This manual is related to the following products: