Extron Electronics VN-Matrix 200 Series - Manual (Page 48)

System Checkup
Follow this checkup to ensure that all VNC 200 devices in your system are online and
correctly configured as either encoders or decoders.
• Log into the VNC 200 Web Interface (see “ VNC 200 Web Interface ”).
• Navigate to the Device List page.
Figure 35. System Checkup on Device List Page
Item Test
Is each device correctly configured
as either
• A PC system/Recorder?
• An Encoder?
• A Decoder?
Unconfigured devices are marked with a .
For recorder information see the VNM Recorder
User Guide.
To configure as an encoder, see “ Configuring a
VNC 200 as an Encoder (Source) .”
To configure as a decoder, see “ Configuring a
VNC 200 as a Decoder (Display) .”
Is an IP address shown with each
device? If there is no IP address shown, then this indicates
that the device is offline.
• Ensure that the device in question is powered.
• Ensure that all network cables are connected.
• Ensure that the device is correctly configured for
network operation.
VN-Matrix 200 Series • System Configuration 43