Extron Electronics VN-Matrix 200 Series - Manual (Page 115)

Network (1 and 2)
Function: Two separate network ports (labeled as 1 and 2). Port 1 is
used for primary network connectivity (for data transport
and configuration). Port 2 is reserved for future expansion.
Connector Type: Shielded RJ-45 socket
Pin-out Details:
Close-up view of RJ-45 female plug
8 7 6 5 4 3 2 1
Data
TX/RX
Network
Status
Shield/
Screen
Shield/
Screen
Pin Function Pin Function
1 TX_D1+ (TX+) 5 BI_D3–
2 TX_D1– (TX–) 6 RX_D2– (RX–)
3 RX_D2+ (RX+) 7 BI_D4+
4 BI_D3+ 8 BI_D4–
Mating Connector: Shielded RJ-45 plug
Recommended Cable: CAT 5E or CAT 6 shielded twisted pair (STP)
Max. Cable Length: 100 meters (330 feet)
Comms Standard: 10/100/1000BASE-T (Gigabit Ethernet)
Ethernet (MAC) Address: Each address is unique and in the format 00:E0:AA:10:xx:yy
where yy is in the range 00 – FF.
IP Address: Factory-set default is:
Port 1: 192.168.0.1
Port 2: 192.168.1.12 (reserved for future use)
Both are user-definable via the serial interface
Optional DHCP mode
VN-Matrix 200 Series • Technical Data 110