Connecting a digital source, Source computer, Network dvi monitor – Extron Electronics VN-Matrix 200 Series User Manual
Page 25: Figure 11. connecting a digital source
Hubs are not suitable for use with the VNC 200 as they restrict bandwidth.
NOTE: For normal VNC 200 operation, use Network Port 1 only.
TIP:
With the VNC 200 powered and connected to a network, the Network
Status Indicator (next to the network connector) should be lit, as follows:
Connecting a digital source
12V DC
5A MAX
POWER
1 — LAN — 2
IN
OUT/
LOOP
AUDIO
SPDIF
REMOTE
TO PC
IN
IN
DVI-I
OUT/LOOP
RS-232
OVER LAN
SOURCE COMPUTER
DVI monitor out
keyboard
mouse
SPDIF audio out
NETWORK
DVI
MONITOR
Power
Source
DVI-D
to
DVI-D
PS/2
to
PS/2
VNC 200
(Encoder)
IMPORTANT!
Fit clip-on ferrite
to this end of cable
PSU
Phono
to
Phono
Figure 11.
Connecting a Digital Source
VN-Matrix 200 Series • Installation
20
This manual is related to the following products: